Thanks for the info
I did not know that the update from 2000 to 2003 was free.
I have seen the new product and you are correct it is very different.
We have had a lot of trouble getting 2000 to post to our machines, we are running siemans 410D controls on our mills and there has been a lot of adjustments needed within the control to get the software to run.
In fact we have only run 1 program to date.
The lathe is running a faunc control so we donot thinck we will have problems posting to it.
I will call onecnc today and see what I can find out
Thanks again for the Info
JBO |