This is what ive tried so far
program#
N001 M127
N002 M17
N003 M126
N005 G20 G99
#3004=2
N010T0101 (ive tried BOTH T0100 AND T0104 before this line and it didnt work)
the meat of the program
G28 U0.0 W0.0
M01
N030T0303 (Ive tried BOTH T0300 AND T0304 before this line and it didnt work)
It is going into an alarm in tool 1 also if there are any wear offsets in tool 1! it is moving to the exact distance of the offset being made! ive tried putting command T0304(BECAUSE OFFSET 04 WILL BE AT 0.0) so it would at least index then i had the T0303 right after - it STILL went into the alarm(EX 260 TURRET CONDITION ILLEGAL) |