My only real experience has been with Turbocnc. Have been using it since V3.?. As previously stated, it is fairly easy to setup if you read the documentation. It does what I want and CV is supposed to be in the next version which is due out at any time.
I like the fact that I don't have to worry about windows. It will run on a minimal machine and due to the environment in my shop (un heated and cooled) I was having a problem with hard drives. So I used a CF card as a solid state hard drive and haven't had a problem since. Made everything read only and don't have to worry about the write limitations of the CF. It won't remember the last position when you turn it off, but I always do a home routine when setting up anyhow.
__________________
Art
AKA Country Bubba (Older Than Dirt) |