Phix,
Thanks for your response.
The biggest mystery is why the control (Yasnac MX-2) will not accept the
"M31" command to over-ride the interlocks and allow me to force the ATC to the "home" condition. (There are four input signals that must be on to confirm "home" of the ATC.)
The manual specifies enabling parameter 7020.0 to "Over-ride Start Interlock", then commanding M31 to enable a maintenance mode that should allow me to execute various m-codes to actuate the various ATC functions.
I've confirmed the MDI mode, EDIT LOCK off, and CYCLE START p.b. input but the M31 will not execute.
A fellow at Mori was as helpful as I could expect, but we were never able to figure out why the M31 wouldn't execute. I tend to think we have a Yasnac problem and hope to take it up with one of their tech guys next week.
If you have any insight regarding this, I'd certainly be "all ears".
Best regards,
emexcee380 |