Originally Posted by HMB3000 ...but it was a bad crimp job so it was not getting a full consent conection... |
I can accept that. My own test for my crimps is to try to pull the wire out of the terminal. If my fingers slip on the wire without it coming out I figure it's a good crimp (I can always pull wires out with a pliers, even on a good ratchet tool crimp.) Short of snipping off all the terminals and replacing them myself, I'm not sure how to do a better crimping test...
Fortunately it is an intermittent problem, maybe one in 20 or 30 machine starts and after the spindle starts once it starts reliably after that.
The door switch is part of the circuit, and I've checked and rechecked that switch. I've never had a failure there.
Randy