Originally Posted by imserv  You should check you e-mail before you post slander like this. The following message was sent to you on January 22, 2009, with the attachments indicated. Maybe your spam filter is set to filter out information that you need.
This board has the same electrical rating as the current production board.
Fred Smith - IMService
---------------------------------------------------------------------
Dear Joe,
I will try to help you, but we don't have much available anymore. The owner should have had papers that show the connections, you may want to double check with him.
It is extremely important that there must be a common ground between the Logic supply and the Motor Power supply. The logic ground and power ground must be the same. If this is not done correctly it could damage the board.
I have attached the only information still available. We no longer support these servo drivers.
This is a servo driver we stopped selling in 2004. The replacement is :
http://www.imsrv.com/deskcnc/#servo
We don't sell breakout boards. We sell the DeskCNC software and control board. We also sell Mach3, but not a board for it.
----------------------------------------------------------------------- |
Originally Posted by imserv I am so impressed with your gracious and winning personality. It was really a pleasure doing business and you are so very welcome. I'm glad we could provide some free assistance to you. Perhaps next time you could call during business hours when we can answer the phone and provide you with more free stuff. 
Fred Smith - IMService
http://www.imsrv.com |
I'm so glad to see this thread. Helps eliminate potential vendors for my future projects.
Won't be doing business with IMService.
My past projects were to convert Sherline mill and lath to CNC then make high performance electric motors for radio control. I sold the Sherline when I moved to England for 3 years. As soon as I build a garage/shop getting something X3 sized and a 10x22 size lathe, maybe bigger.