Yes, three rectangles is correct. What I am looking at doing, is cleaning out the middle of the rectangle with the first fly cutter. That is what I am calling the middle of the program. Let's say my door is 12.0 = #501 and 14.0 = #500
After running my current program there will be a 2" in the "Y" direction and a 4" piece in the "X" direction left in the middle.
I want the cutter to know that based on the size of the door, the size of my stiles and rails, the diameter of the cutter, that there is still more material to be cleaned out. No matter the variables in #500 and #501
I tried attatching a picture, but it failed to upload??
O453(PRODUCTION SHAKER LEFT)
N10G0G17G20G40G49G80G90Z0
M211
M400
M402
T10M6
#1=3.6875(FLY CUTTER)
#2=.375 (Z DEPTH)
#3=2.5625 (1/2" CUTTER)
#4=2.375 (1/8" CUTTER)
G08P1
N20G55M91S15000X[#500/2]Y#1
N30G43H42Z.25
N40G1G90G1Z-#2F200.G61
X#1F300.
N50Y[#501-#1]
N60X[#500-#1]
N70Y#1
N80X#1
(HERE)
N90G40G49G0G64Z0M95
M400
M401
T9M6
N100G54M91S20000X[#500/2]Y#3
N110G43H9Z.25
N120G1G90Z-#2F162.5G61
X#3F325.
N130Y[#501-#3]
N140X[#500-#3]
N150Y#3
N160X#3
Z1.0
N170G40G49G0G64Z0M95
M400
M402
T11M6
G55M91S18000X[#500/2]Y#4
N190G43H43Z.25
N200G1G90Z-#2F25.G61
X#4F200.G61
N210Y[#501-#4]
N220X[#500-#4]
N230Y#4
N240X#4
Z1.0
G0G40X6.Y6.
N250G0G49G64Z0M95
M12
M22
G53Y0
N260G08P0
M212
M99
%  |