Originally Posted by justgary 
P.S. [off topic] Is it the use of subroutines that changes the position offsets in "wizard" code? I think it only happens when I dry run one and stop it before it completes. I tend to do that often, and have toasted myself several times because of it. I'm now very leery about using a "wizard" at all.
|
i can't remember what the code is off the top of my head but look for the "cancel tool height offset" code in your wizard program. i was fighting one of the wizards for a while trying to figure out what was going on as it kept trying to bury my cutter at the start of the program. it was putting that code in there for some reason.