Hi, we just made the switch to NX6 (from 5). I'm not sure about NX4, but you can switch back to the "Mating Conditions" you see in version 5 by selecting the following from the top menu bar in NX:
-Preferences
-Assemblies
-In the "Assembly Preferences" box that pops up, in the bottom
pulldown box called "Interactions" you can select between "Assembly
Constraints" (new) and "Mating Conditions" (old).
I have not figured out how to keep theese settings when you exit out and come back into NX, so I have to remember to set it every time.
Hope this helps.
__________________
It is the poor craftsman that blames the tool |