Here is part of the gcode of the time I broke the bit. Top of stock is at .5" 3 passes to cut through. Plunges at 2" and cutting at 3". Circle is broken (by the POST Processor) into 4 quadrants. The feedrate of the G03 was ignored. The plunge feedrate of F2 is fine.
Eric
G00 Z1.5
G00 X6.9979 Y9.861
G00 Z.6
G01 Z.3 F2
G03 X5.5604 Y11.2985 R1.4375 F3.
G03 X4.1229 Y9.861 R1.4375
G03 X5.5604 Y8.4235 R1.4375
G03 X6.9979 Y9.861 R1.4375
G01 Z.1 F2.
G03 X5.5604 Y11.2985 R1.4375 F3.
G03 X4.1229 Y9.861 R1.4375
G03 X5.5604 Y8.4235 R1.4375
G03 X6.9979 Y9.861 R1.4375
G01 Z-.1 F2.
G03 X5.5604 Y11.2985 R1.4375 F3.
G03 X4.1229 Y9.861 R1.4375
G03 X5.5604 Y8.4235 R1.4375
G03 X6.9979 Y9.861 R1.4375
G00 Z1.5
G00 Z2
G00 X0. Y12.
M05 (Spindle off)
M18 (Drive off)
M02 (The End)
__________________
I wish it wouldn't crash. |