Converterk
thanks for the reply, I went ahead and ordered the encoders from US DIGITAL # E6D hope they work,
Built mounts for my SEM motors over the week end at work so I
should know if they work some time this week.
Also had to change out the pin in the end of the motor. Went
from 5mm to .250 and .875 lenght to make it all work.
Seems that you have been doing some retrofits to ajax lately
any thing I shound look out for ?
Thank Brad
__________________
IF ITS NOT BROKE YOUR NOT TRYING HARD ENOUGH
Ashes to ashes , dust to dust , If it wasnt for Harleys the fast lane would rust.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Last edited by MILLMANM; 12-01-2004 at 09:25 AM.
Reason: add pictures
|