Originally Posted by FrankG Phil,
Thanks for the reply... & the website hosting the circuits, PCB layouts Etc...
It looks like a tremendous amount of work to have compliled, tested and assisted the various users that have given it ago...
I'll finish the 99 page Open Source thread, before I make any solid plans...
I'm in an awkward position with this controller as I already have the 5804's and a circuit that I know works (original CWTech that's been floating around for a few years...), But I also know that this just won't cut it on the machine I'll be using it on...
Again, thanks for all the work you, Tach and possibly others have put into the open source designs... |
Have you looked into HobbyCNC drivers at:
www.hobbycnc.com
Dave Rigotti