Deckcnc board and homing switches | |
I'm having a tough time trying to get this board to work, the home switches do not work under any circumstances. The only way to home the axis was to use the limits. The one thing about that is once it’s on a limit the axis will only move .001 at a time, which means it, takes a long to come off the switch.
Is anyone using the new board does that one work?
__________________
Thank You,
Paul G
Site Owner-Webmaster-
Administrator
www.rfqwork.com
www.cnczone.com
www.welderzone.com
Last edited by CNCadmin; 11-27-2004 at 11:41 PM.
|