[Karl_T]

I have a nine input button setup for my four axis mill with galil card. The buttons are arranged in three rows of three buttons and are connected to inputs 1-9. My present host level program uses the center button for hi/lo speed jog, and the perimeter buttons for axis and jog direction.


I'm looking to write a Galil program for a better "jog Buttons" routine.

I've been reading the Galil command reference, and such a program is certainly doable. But, it will be a bit of a challenge for me as I've never programmed in native Galil.

This must be a common need. By chance has anyone seen a similar Galil "jog buttons" routine?

Karl