Hello,
I am a new member to this community,
Regards and good wishes to all,
Recently I purchased an Old Mori Seiki Lathe with Fanuc 6ta control
which has only LED single line diaplay and no CRT,
The Machine is working fine, the problem is entering program manually
which takes lot of time, hence I need help interface the machine with
pc for rs232 communication. The machine has one blue honda type
connector with 20 pins, i dont have any manuals. how to convert this
port to rs232 and also what are the parameters and settings to be made
for transferring programs from PC to machine.
Hope I will get a reply ASAP,
Best Regards,
Raju.C
innovativecnc@yahoo.co.in