I've seen some posts of the costs in different machinines.
Here is my break down:
Aluminum ($1.00/ pound at scrap yard) $105
motors / driver / wires $180
ballscrew $77
ballscrew nuts $62
drill rod (guides) $55
igus bearings $68
misc bolts $20
transformer $36
case $45
turbocnc software $20
kress router $437
TOTAL $1105
Plus the computer (that I already had. )
I don't know yet what I will spend on a table top. The lamanited insert for a kitchen table is working so far. Any suggestions?
I estimated about 200 hours work. (very rough estimate)
Bill |