Thanks for the reply. I was told my 5 wire unipolar stepper motors wouldn't work with this board. I found some bipolar motors today that are a perfect match volt and amp for the board and my power supply, with double the torque too. I was told of a site
http://pminmo.com/PMinMOwiki/index.php5?title=Main_Page that answered my questions about wiring the motors and Limits so Im guess I am on hold until the Post Lady delivers my new motors.
As to why I labeled this thread the way I did: The board is as it is. if it had come with a wiring diagram I would have had no need to make a post at all.
If I had it to do over again. $50.00 for the 4 axis controller $27.00 for the three motors and $35.00 for pipe, aluminum channel, screws and bolts plus some scrap UMHW and angle from my shop and I have a CNC Mill for less than the price of a GECKO Drive. Yep you get what you pay for and yes I would do it again.