Rekd, when you say it's ok to have the two g's on the same line, are you talking about TurboCNC, or g-code in general? Also, I have re-read the instructions, and I have also noticed this |
that's on a fanuc or most fanuc compatables.
Try replacing the "Q" with an "L" and see if that works.
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |