On my homemade router I plan to blow air into the cutter to loosen up the chips. On our point to point at work, I find that most of the chips get packed into the groove. If I'm trimming an edge, I get pretty good dust collection. Now if you're talking about the chips from boring, most of mine remain lying on top of the workpiece.
Gerry
__________________
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |