Kmed
I position the swivel head manually to be perpendicular to the new plane.
I am not rotating my part on any axis.
To get the incline plane into the controller I run :
G49 A45 B45
The incline plane is now created in the controller (45deg on X axis (A) and 45deg on Y axis (B).)
All movements from now on are orientated to this new plane until cancelled with:
G49 or
G49 A0 B0 C0
I understand my version is 'C'
I have been back to the supplier who are talking to Fagor.
It was said my software should not have a problem as this had never been reported before.
I am trying to establish if any other people are having the same problem.
Thanks
Kiwi |