I have a "borrowed" copy of mastercam X2. I have had it just a short while and haven't gotten into it to much. I have been using Millwrite 2000 for about 2 years for engraving and other 2D stuff. its biggest crux is that it only imports autocad 14 DXF files. I tried to use mastercam to convert EPS files to dxf. millwrite and autocad 14 won't open them. is this because mastercam saves in autocad 2000 dxf? I was told that they are different. I have been learning this craft on my own in my backyard shop so any help i can get will help. Don't assume i already know something because I probably don't.
__________________
RACECAR,SPELLED BACKWARDS,IS RACECAR |