[Grifftek]

Thanks for the response

I have not yet figured out how to create the regions, but I will figure it out when I get some more time on the program.

On the parts in the picture I am purpopsely leaving the finish rough or grainy like that to save on machine time as this is an acceptable finish for the part. I just spoke with my friend this morning after he seen all the pictures and he says its fine. The parts will be anodized and the look may be appealing to some and maybe not to others.

I have spent several more hours trying to figure out VM than I have meshcam or cut3d. I am new to all of these programs. It seems like you need to be a rocket scientist to figure out VM and a mere mortal can get decent output from meshcam and cut3d as they are very simplistic to use.

Does anybody have any programs they can email me that I can disect and see how you have programmed them?

You can email them to grifftek @ grifftek . com or put them somewhere I can dl them

Thanks
Bill