So,
I figured I would get all ready for my new thrust bearing install later this week on the Z axis, and tried as I could, could not get the NUT off. So, me being the overly smart one, I removed the screw from the nut, all in one piece, that is, until all the little itty bitty BALLS fell out of the nut.
So, to say the least, I am a dumb ( fill in the blanks ).
Now, anybody know the BALL count in the nut, and is it possable to re-install these little buggers, any pre-load.
Yep, you are more than welcome to let me have it.
Thanks for any help ,
Smitty |