Ok touchy subject 3d scanners I went to a rapid prototype show a few months ago and there I have seen many of these some could go as far as 2 microns but some are cheap if you are going to get one I would say dont buy until you see it work and I mean in front of you all of them shown their parts but what you dont see is any adjustments they have made to get it that way. I have seen some work great for a budget of over 20,000.00 and I have seen what they shown me of cheaper systems but they did not let you stick a part in front of it for yourself? Wonder why? Just be very carefull this is new you know what that means with products. |