Boss 6 requires no decimal point in the feedrate and f100 is a feedrate of 10 IPM, etc.
G75 is for multi quadrant. Should not affect anything.
Safety line should have a G40 in the beginning.
Why the M01 in the beginning?
If this is generated by a CAM, it may have unseen control characters causing the control some confusion.
Write a simple program in MDI store and see what it will do. See operating or programming manual.
The ZDI is the clock card and has points where parts of the board kick in. But this would not be affected by block vs run.
George
__________________
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
|