 No rapid on Z Axis with G0 | |
All,
I have a program I was working on and if I run it block by block in the machine, it runs fine, but if I run it in auto, it runs line N30 and skips right to line N60. So it misses both of the Z rapid moves and runs the G1 feed move of the -.375. Would nayone have any ideas why it would miss those two lines?? Its as if it does not even see them...
%M01
N10 G0 G90 X-10.0 Y-5.0 T1 S600 M06
N20 G75
N30 G0 X3.9625 Y-.425
N40 G0 Z.25
N50 G0 Z.1
N60 G1 Z-.375 F40
N70 G41 X3.9625 Y-.425 F60
N80 Y-.925
Thank You,
Brad |