[tom.jelly]

I figured out about the axis change buttons after that last post (I do need manuals!) ....and yes, I changed over the transformers:
voltages off of t2:
13/14 71vac
16/15 76vac
12/11 72vac

at sx1 input side
47/16 73vac
sx2 input side
46/14 69vac
sx3 input side
45/12 71vac

sx transformers:

output side, with override light illuminated:
at sx1 output side
43/74 50vac
sx2 output side
42/74 53vac
sx3 output side
41/74 38vac

output side, with axis selector set to z:
at sx1 output side
43/74 38vac
sx2 output side
42/74 22vac
sx3 output side
41/74 71vac

output side, with axis selector set to y:
at sx1 output side
43/74 38vac
sx2 output side
42/74 84vac
sx3 output side
41/74 78vac

output side, with axis selector set to x:
at sx1 output side
43/74 38vac
sx2 output side
42/74 24vac
sx3 output side
41/74 32vac

It seems odd to me that it would be a transistor problem on ALL 3 AXES, I could see if it was one or two- do these voltages look correct? if so I'll desolder some transistors and check them....

thanks
tom