Originally Posted by Kookaburra DeskCNC does have driver boards to compliment their controllers as well, they do a small servo drive 35V 5A and a micro stepper controller board. |
The SV500 is a single axis, step and direction, servo Driver. It is rated at 30vdc max and 5 amps. It has automatic current limiting and thermal protection. The PID loop in contained on each board and there is an enable line that faults all axes if one faults.
SV500 servo driver info
These motors were spec'd to match the SV-500 servo driver boards:
Servo motors and power supply kit
We also have an inexpensive 4 axis stepper driver, based on the Allegro A3977 chip. full, half, quarter and 1/8 micro stepping.
4 axis stepper driver board
Fred Smith - IMService