Yo gdl357 .
What lathe do you use?
Konstantin |
I Own a Micro-Mark 7x14 Version #82710 with Digital Readouts so it can do mm or SAE. My first lathe, and am happy with my purchase. I did want a JET lathe, but that was too big.
http://www.mini-lathe.com/Mini_lathe...Micro-Mark.htm
******Update*******
Just a quick mod to the knurler.
Drill an extra set of holes closer to the center hole so u can screw the upper and lower pieces closer to the center so they wont have a rediculous angle when you knurl small round like 1/4". This way you will have two settings, one for over 3/4" and one for below. 1/4" closer to the center hole is good.
something like this
[_o__o_______o_______o__o_]
Line art.
