I agree Leeway,
I didn't bring up this issue to be contentious, but to get back to work. This isn't a hobby for me and these problems have cost me untold thousands of dollars and hours of heartache. I tried everything suggested to me to get back to work.
I've talked to the makers of every part in my controller and a couple of electrical engineers. I've even had one come about 3 1/2 hours drive to my shop to check out what's going on. We even put an oscilloscope on my outlets and checked the power for stray signals. Nothing there.
I have a whole controller built by a big cnc company on its way here this week. I can't mention the brand for obvious reasons. I am thinking about taking the 201s out of the loaner controller and putting my 202's in there and see if the problem follows them. I may not post the results here though since I am personna non grata for having problems and the point would be moot.
To you guys asking for free drives; That isn't going to happen. When I get my money back, the drives will go back to Gecko. Doing anything else, even though Mariss said differently, would be stealing from Gecko in my opinion.  |