Sorry guys...I saw the H and thought we were talking about a Horizontal..
But HL2 is an early lathe..my mistake. So forget the part about a hydraulic counter balance.
Todd, For a HL2 it does says Alarm 134 is low hydraulic pressure and also mentions phasing to the hydraulic motor. Have you checked the power to see if you are getting all three phases and that they are up to spec? Just a thought.
I don't have access to a HL2 wiring diagram... so not much help. There should be one in the back of your Haas manual.
__________________
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |