[cyclestart]

Here's a few screenshots.
The apps on the cube are sheetcam, qcad, emc2, and gedit showing the gcode.

Now can someone please translate this to English?

chord_deviation
	sx=-8.128000 sy=24.003000
	ex=0.000000 ey=15.875000
	cx=0.000000 cy=24.003000
	r=8.128000 th1=3.141593 th2=4.712389
	included=1.570796 mid=3.926991 dev=2.380636 tol=0.000000
chord_deviation
	sx=0.000000 sy=15.875000
	ex=0.000000 ey=15.875000
	cx=0.000000 cy=0.000000
	r=15.875000 th1=1.570796 th2=-4.712389
	included=6.283185 mid=-1.570796 dev=31.750000 tol=0.000000
chord_deviation
	sx=0.000000 sy=15.875000
	ex=8.128000 ey=24.003000
	cx=0.000000 cy=24.003000
	r=8.128000 th1=-1.570796 th2=-0.000000
	included=1.570796 mid=-0.785398 dev=2.380636 tol=0.000000

The program ran in sim mode but the terminal spit out lot's of these