After reading a lot more, realized that If I wanted to do
inlay work, some woodcarving, some light ali work,this
design was just not going to cut it.
So I bought some more stuff and off I go again.
Got a couple of thk rail sets srs15's 21 1/2" (x)
and rsr12's 14 1/2" (y)
some delrin motion slides (z)
3/8 16 acme lead screws with delrin for nuts (x, y)
and a ball screw for z
some more ali and i'm off and running again.
I'll be using the 4axis hobbycnc 31v setup, complete
with 80 oz steppers. Done and finished waiting for
machine.
Like most of us, all I need is time. |