Here are a few lines of the code:
N2585 X1.1739 C252.029
N2590 G03 C264.251 R1.1739
N2595 G01 X1.168 C270.
On line N2590 to G03 doesn't have X-coordinate but it requires one to run. Without the X-coordinate I get the error 303 which I talked about in the original post. Do you know how to change the Post in CAMWorks so it gives the X-coordinate? I could manual change it but there are about 50 of these errors. Does this sound like a post problem to you? Thanks |