this is an older post, so this has probably been fixed by now.....
G54
G00 G53 X0 Z-15.
G50 S2000
G96 S550 M03
X-2.480..............are you sure you want to go to X-
Z.1
G71 P101 Q103 U.02 W.0 D.055 F.0085....if boring, shouldn't the U be minus?
N101 X2.76
G01 G42 Z0. F.004
Z-19.
X-2.5 Z-19.207.........same
N102 G40 X-2.480......same
M09
G00 G53 X0 Z-15.
M30
also, on my CL's noes comp is not turned on during roughing, only gets turned on in finish cycle...G70 P101 Q102
when comp is on, any move straight up/down in X needs to be at least twice what comp value is. |