Originally Posted by Xerxes  Yes, many have used CNC4PC boards with them. Any step/dir board should do. However most of them don't utilize the fault signal from drive I think.
The assembled BOB's will be for VSD-E drive. 50 pcs of them have been already ordered from factory. |
Thanks Xerxes,
Have you considered spindle speed control with the new BOB?
What also comes to mind is that if the VSD-E can handle sinusoidal AC motors, is it so that one VSD-E could be used instead of a vsd unit to control the spindle speed (1-phase 220V AC motor)?