Krista,
It would depend on how much memory was ordered when the machine was bought.
You could get 1 meg of memory in 94 but it was an option.
Go to the "Programs List" Page. Look at the bottom of the screen and it will tell you how memory is left, (in a percent with the programs that are loaded). And with some quick math you can figure out the total memory available.
You still can upgrade to more memory. But it takes a board change out as the memory is soldered to the board. And it is not cheap.
Did you know you can DNC your programs to this control?
__________________
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |