Originally Posted by wjbzone Thanks Matt,
...I am never sure if I'm missing something with Gibb's or it just does not work. ...
Bill |
That was always a problem when I was using it too. I think they've got a lot of those things 'fixed'
Originally Posted by wjbzone ,,,If you try to copy and paste a line of code into At Op End, it does not work. Is this right?
Bill |
I don't remember trying that when I was using it. Did you try CTRL+V as well as right clicking and selecting PASTE?
__________________
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |