I have over 20 cncs that I work with and maintain.
I have them all hooked up to my dnc server and have never had a problem till now.
I have a mori tv30 with a Mits. 50m Jr,
contoler.
I have wired it and set the parameters as I have with all my other machines and cannot get thes controler to comunicate.Ive checked all the wires and have now gotten my laptop out checked it works with the other machines,it does,but it will not work on this machine.
I have now gone right back to the board and made my conection there.Still no luck.
What is the proceedure for OHMing out the board at the RS232 connection.
I can see the program being sent from the machine when I do it but cannot recieve it so I wondering if I have a bad board?
Any ideas as to my next move?
