hey guys i am looking at
converting a machne we build at work
from the massivly expesive and propritary system we are using at work
to a set of 3 gekos and a break out board
what I need to know is what kind of through put can I expect to get running from a printer port or should I go custom stuff from usb
and I if I go usb I'll see if I can pass the info on for all of you guys
we are spending $20,000 for a servo controller now that only gets us about 300 350 ipm on so I'm looking to curb that a bit I'm not looking for fdaster
I'm looking to get into something cheaper and easier to work with
so we can afford to stock replacment parts
any help would be great before I take my sugestion to the boss and look like a fool
Last edited by broncosis; 07-29-2004 at 01:08 PM.
|