Thanks 9 1/2 for the link!!! Isnt DOS just fun!
Machintek!!
The DOM was preloaded with DOS 6.2 and EZTRAK Contol Software 6.00-5.78
The mainboard upgrade kit was actually a whole new computer consisting of an ISA Cardbus and a Single Board Computer.
I have a question though. The control software is only operating in 2-axis. Is there a way to activate the the third axis or is there separate software for 2 and 3 axes?
The install was a breeze. I couldn't have done it without the help from here.
THANKS VERY MUCH!!!
Hexus |