Hello,
I bought this Eagle machine (Bridgeport Clon) with an 1991 Anilam Crusader control. It worked fine for a couple of months until it got a burned board. After several repair attempts I decided to buy an Ajax Control. I installed myself within a week (working at nights after regular work). I spent about $4000.00 in the control and a computer (I put it inside of an electronic cabinet).
I have been working with the new system for about a year. I bought a few months ago the pendant control for $634.00.
I can tell that this is one of best decision that I have made. It never fails. I even have experimented strong power failure( the power is not too good over here in Puerto Rico). This control is high speed machining capable so I can work with 3D shapes at 200 ipm.
I strongly recommend this Ajax Control.
Regards,
Luiguicam |