So you are trying to set machine Zero-position, I have an O&H ACT-20 with the Fanuc 18t, I had to set my home position a few months ago. I wrote done the steps and I will find them and get back tomorrow. Did the batteries get low and you lost home position? Thats what happened to me, I bought my lathe used, I may have some phone numbers that could be very helpful. I'll pm you tomorrow. Yes Okuma has bought O&H out, if you go to Okuma's web site and look at the Millac line of mills and lathe's, you can see they have started putting Okuma controllers on the new machines. |