i am still out on what vaccum motor i'll use as i am learning more all the time
bill is fabricating my table in the original quote, i am learning though that i know i want 8 zones not 4 and i may consider going for the t solt aluminum with vaccum holes as i am learning about how easy it could be to just clamp some carvings.
i laid out my software already, but will purchase cabinetpro, i sat down at kieths shop and laid out cabinets in 10 minutes on it and have no doubt it will do what i want, i must say when i got an intensive library wall or theater,
for the most part i lay it all outy in scale with cabnetware then take it to a board and hand draw the rest of the details.
i do have cabinet parts pro and will use it for the melamine casework guys
but i will switch to cabinetpro full time eventually,
dudes it is commercial time oop's i mean super bowl back in a bit jim |