I am new to this group, I just signed up to see if I can get some info on a dynamyte 2200 that I bought. The machine works fine, I can enter programs and run them. I was just wondering what is good as far as a cam package. I checked out sheetcam and it seems pretty good. I guess I don't know how to actually transfer the info into the machine. The machine came with a cable to connect to a parallel port, but after plugging it in I am completely lost. I am quite familiar with programming and running cnc machines but setting up the electronics, well it just confuses me. Like I said I am new to this, so I'm not sure if I am even in the right area. If anyone can give me any advise or suggestions I would appreciate it.
Thanks |