I built one of the 2 amp board kits that Dan sells. It went together fine and works fine too. It is now sitting in a box with three 118 oz 1.5 amp .9 deg stepper motors. The 2 amp board from Camtronics works great. The maximum voltage the board will handle is 18VDC. I was going to do something with this stepper system but I have now moved on to servos.
__________________
Thanks
Jeff Davis (HomeCNC)
http://www.homecnc.info
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Last edited by HomeCNC; 05-26-2003 at 07:36 PM.
|