Originally Posted by cadcam  Right click on the Geomitry in the ops Mgr and then pick the chain and right click. from here there is an option of "Start point" this will give you the option for move to the next end point forward or back or Dynamic along your chain.
PS is good to state what version of X example. Mastercam X or Mastercam X-MR1 or Mastercam X2 and so on. |
I'm using Mastercam X. When I do this the "start point" command is ghosted out. I failed to mention before that this is a selection of multiple 2d contours all in the same plane. My goal is to have the mill machine this contour in 20 different parts in the same setup, all starting and ending at the same location on each part. I'll see if I can get a screenshot of what I'm try to do when I get home (at work right now).