I have been looking at the Lathe Turret Plans on
http://www.nwstp.com/jsm/turrett.pdf
As far as my mechanical understanding it still allright I would say that it is not going to work as it is drawn and shown in the general drawing.
The spindel cannot move to the left because it is against the housing. So the turret can not be locked while the subplate can't move.
I'm also looking to obtain the Turret Plans mentioned on
http://www.issintl-inc.com/latheturret but my e-mails are'nt answered.
Any alternative to get hold of these plans?