Ok I will start the tests.
The first time I'm at home is tuesday and i'll do them then.
As for the Logic probe, can I use the logic probe from the Interface board? see page 3 of the following documentation
http://pminmo.com/4axis/4axisBOBdata.pdf
The logic probe from this board is working.
As for connecting the J1 jumpers in Full step mode, is my assumption in the following link ok?
http://pminmo.com/PMinMOwiki/index.php5?title=Picstep Below the Pull up resistors you can see the possibility to place jumpers. These jumpers set the mode (full,half,1/4 or 1/8) of the PICstep. The modes are set as following (positions from PICstep.jpg):
1/8th: No jumpers
1/4th: Top right to bottom right wired
1/2: Top left to bottom left wired
full: Top left to bottom left wired and Top right to bottom right wired |
I'll have a look into the jogging function of MAch3. Don't know yet how it works. The setup of MAch 3 is ok atm I think