[Rekd]

Originally posted by Sanghera Hi all, I was just wondering what units Mastercam is in, I know this sort of sounds stupid, but I'm not totally sure. Not only for measurements, but also for things like speed and feed rate. Thanks.

RPM, Feed rates, Retract rates etc. are in Revolutions per Minute and Inches or Milimeters per Minute depending on what you're looking at.

There's a TON of help associated with each control in almost every dialog box. Use the "?" at the top right corner of each dialog to get the tool tip help shown below, and definately READ the help files. They are invaluable.